Heavy Duty Slurry Pumps For Aggregate Processing , Slurry Pumping
Slurry pumping system is more than important to the mining sectors,
esp. for the tailings disposal applications. If you need heavy duty
three-phase pumps with high volume or high head capabilities, SME
has a wide range of slurry pumps designed for tough mining and
industrial applications. All of our pumps are interchangeable.
SBH slurry pump is a good solution for coal washing, coal washery
plants. SBH slurry pump is heavy duty, high head, hard metal
design, which at the same time, is higher in cost than other series
of slurry pumps. SBH slurry pumps are available from size 1''
(25mm) to 6'' (150mm).
Pumps for tailing: Depending on particle size both rubber and metal
pumps can be used. Pumps for hydrocyclone feed: For sharp
classification use horizontal pumps type SH. Pumps for pressure
filter feed: High head needed with variable speed control
(alternatively two-speed drive). Pumps for tube press feed: Small
flow and high head, use metal pumps of type SH. One pump can feed
many tubes by a slurry distribution ring. Pumps for dense media
(heavy media): High inlet head and high percent solids in
combination with low discharge head can cause expeller seal leakage
problems. Pumps for general purpose (mineral): Horizontal pumps are
ideal for normal duty in mineral process circuits. Rubber is
normally preferred in[hard rock" concentrators.
|Rated Motor Power||260Kw|
Construction of SBH Metal Pump:
Standard Material of Wet-end Parts: Hi-Chrome Alloy A05
Pulp and Paper
Heavy Refusal Removal
Projects with SME SBH Slurry Pumps: